Advice On How To Do Plumbing Right
Are you doing your own plumbing for the first time? You probably don’t even know where to start. It’s no secret that doing your own plumbing for the first time can be a bit overwhelming. Below are some tips that can help to make maintaining your own plumbing a bit smoother.
When choosing a plumber make sure he is insured and licensed. This is very important. If there is a plumbing emergency, you want to make sure the plumber has met the training requirements of the state. If he is insured, this covers any accidental damage done while fixing your plumbing.
Before you start a plumbing project you should tighten all of the pipes that are easily accessible. Especially if your pipes are making a range of loud banging sounds, as this is a clear sign that there are loose pipes along the line. It is also a good idea in case there is a clog so the excess pressure released does not break a loose pipe.
Do not fall for the idea that liquid grease can be easily washed down the drain with hot water. While the grease may flow past the initial drain with the water, it does not take much of a temperature change as it moves through your pipes to alter from liquid to solid. The repeat habit of dumping grease in the sink is a sure-fire way to ensure a hard-to-reach clog forming in the future.
Certain things shouldn’t go into your plumbing system. By knowing what you can and cannot flush or throw into the garbage disposal and sink, you can save yourself from a costly repair or disaster. A plumber can usually get your plumbing back into working condition but can be avoided if you know how to dispose of items correctly.
Check your gas water heater periodically to make sure the pilot flame is lit. The correct color for this flame should be blue. The tip of the flame should be yellow. If you find that you are only seeing a yellow flame, you may need to call a professional for safety reasons.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
As you have seen, doing your plumbing is not as scary as it may appear at first. Just think of all of the benefits it has and all of the expenses it can take care of, along with all of the money it can save you in the long run.